Transactions on Transport Sciences 2012, 5(2):91-98 | DOI: 10.2478/v10158-012-0011-6
Experimental Research on the Parameters of Electric Vehicles
- Department of Vehicle Materials and Technologies, Faculty of Metallurgy and Material Engineering, VĹ B -TU of Ostrava, Czech republic
This paper describes the methodology and measured results obtained by monitoring the drive and electric vehicle management. It describes an application for recording functional values during the operation of The StudentCar Electric developed by the Department of Vehicle Materials and Technologies. The end of the article is devoted to the comparison of measured and generally available data.
Keywords: electromobility, electric vehicle, BMS.
Published: June 1, 2012 Show citation
References
- Čech, R., Buřval, L., Klaus, P., 2011. Measuring the Electric Strength of Board Composite Materials and Insulators. Transactions on transport science, vol. 4, no. 1, pp. 19-24. ISSN 1802-971X.
Go to original source...
- Macur, J., 2011. Alternativní pohony v dopravě: Technická, ekologická a sociální analýza [online]. Asociace elektromobilového průmyslu. [cit. 2011-11-03]. Retrieved from: www.elektromobily.org/w/images/6/66/AltPohVDopr.ppt (in Czech)
- Plichta, V., 2008. Bohatší vybavení automobilů působí proti redukci jejich hmotnosti. Technik [online]. [cit. 2011-11-03]. Retrieved from: http://technik.ihned.cz/c1-28859510-bohatsi-vybaveni-automobilu-pusobi-proti-redukci-jejich-hmotnosti (in Czech) ThunderSky, 2007.
- ThunderSky: Lithium Battery [online]. [cit. 2011-11-11]. Retrieved from: http://www.everspring.net/TS-LFP100AHA.pdf
This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0), which permits use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.